Expert Answers about Keystone Everest Fifth Wheel
- Recommended Landing Gear Motor for a 2010 Keystone Everest 5th Wheel
- To replace your current 125340 motor, you will need the # LG-142178. This will be a direct replacement for your current motor, but you may consider replacing the gear box as well. For that you will need the # LG-179015. These together should get everything working properly for you.
view full answer... - Recommended Replacement Landing Gear For 2008 Keystone Everest
- Since the 2008 Keystone Everest Fifth Wheel weight ranges from just over 9000lbs to just under 12000lbs, I recommend the Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs Item # LC333964. This kit comes with the replacement switch and is a weld on system.
view full answer... - How To Find Correct Replacement Axle for Coleman Fleetwood Popup
- In order to find the correct replacement axle for a trailer you'll need to know which type of axle you have, torsion or leaf spring. Then, you'll note the axle capacity which can be found on the axle tag. Finally, you'll need to measure the hub face and spring center length. The Dexter Trailer Axle Beam part # T3584F-EZ-8974 for example is a leaf spring axle with a 3,500 lb capacity that measures 89" long from the face of each hub. I have attached the full list of options below.
Once you...
view full answer... - Correct Replacement Rear Electric Stabilizing Jack for Keystone Everest 5th Wheel
- I am not sure what rear electric stabilizer jack a Keystone Everest 5th Wheel uses but if it's a Lippert product then the Lippert High-Speed Power Stabilizer Jack part # LC298707 is likely the correct replacement. It will wire up to the existing switch or you can use the one that comes with and should bolt on using the same holes as the old model.
view full answer... - Best 5TH Wheel Storage Cover For a 2008 Keystone Everest That is 37' 4" Long
- I recommend the Adco Olefin HD All-Climate + Wind RV Cover # AD79ZR for your 2007 Keystone Everest 344J camper. While there is not any custom fit covers for your Everest this cover is designed to fit your a 5th wheel camper that is 37'1"-40' long. I verified that your Everest is 37'4" long so this cover is the correct fit. The Olefin is the newest and best cover available from Adco. It will protect against wind, sun, snow, and dirt and is great for long term storage.
The 293P and 295TS...
view full answer... - Solution for Mounting Rear Jacks of Lippert Ground Control Where There's Interference on RV Frame
- We've spoken with Lippert in the past about alternate mounting locations for the rear jacks if there is anything that would interfere with the recommended dimension. Here's what they told us as far as where you can mount the jacks on the frame:
If the customer was to take a string from the bottom of the rear most tire and run it to the bottom of the rear bumper, the jack would need to be above that line. As long as the jack is above this line, then yes they can install that far back. If...
view full answer...
Go To Results